You need an extra tap for the garden or want to connect a sauna or outdoor shower to an existing pipe, without cutting the main and fitting a tee. That is what a tapping saddle is for: it clamps onto the pipe and the branch is made through a single hole. The job takes half an hour and needs no welding.
What the diagram shows
1 — the HDPE pipe, 2 — the two-piece bolted tapping saddle, 3 — the threaded branch with a ball valve, 4 — a drill passing through the open valve.
Choosing a saddle
- By the pipe’s outside diameter — 25, 32, 40, 50 or 63 mm, printed on the pipe.
- By the branch thread — 1/2", 3/4", 1" and up. The branch cannot be larger than the pipe: a 32 mm pipe usually takes 1/2"–3/4".
- The saddle is rated for the same pressure as the pipe — check the PN marking.
Installation step by step
- Shut the water off and release the pressure — easier and safer.
- Clean the pipe section of dirt and sand: not a single grain should sit under the sealing ring.
- Fit the lower and upper halves of the saddle (2), with the branch facing up or to the side where the new line will run.
- Tighten the bolts evenly, in a criss-cross pattern, so the saddle sits square and the ring is not skewed.
- Screw a ball valve (3) into the branch with thread sealant.
- Drill the pipe through the open valve with a plastic drill bit or hole saw (4), 4–6 mm smaller than the branch’s internal diameter. Drill slowly and straight.
- Withdraw the drill and flush the branch so no swarf enters the system. Connect the new line.
Technically you can tap in under low pressure: drill through the open valve and close it as soon as the drill comes out. But water will spray and swarf will go into the pipe. On a water utility street main, tapping is done only with permission and by the utility itself.
Where a saddle will not work
- On PP-R and multilayer pipes — use a tee or a weld-on saddle instead.
- On old, cracked or badly scratched pipe — the ring will not seal.
Saddles are grouped in tapping saddles, pipe in HDPE pipes, fittings for the new line in 32 mm HDPE fittings, valves in 1/2" ball valves. How to assemble an HDPE line — see “HDPE compression fittings”; summer plumbing — here.